#Aja lut box vs boxee generator#
#Aja lut box vs boxee software#

Otherwise, click the Calibrate Cube LUT button to proceed directly to the Display Calibration section. Click the Display Optimization button to proceed to that workflow section. If the Performance Analysis page indicates any red lights for display performance, you may wish to optimize the display’s picture controls before creating a 3D calibration LUT. In the Display Pre-Test section of the Color Cube workflow, you can measure the performance of a display before you calibrate it, on the Gamma & ColorChecker page and on the Advanced Linearity page. On the Session Options page, under Input Signal Levels, select ‘Video (16-235)’ (CalMAN currently supports only this range for the AJA LUT-box).

#Aja lut box vs boxee generator#

Under Model, select ‘SpectraCal - Cube Generator (Resolve)’ (the AJA LUT-box loads the Resolve 3D LUT file format). On the Display dialog, under Manufacturer, select ‘SpectraCal.’ On the Session Setup page, click the Find 3D LUT Device button. Shoreline, WA 98133 USAĬorporate: +1 2 | Tech Support: +1 2 | c. On the Source dialog, select your desired test pattern source.ġ7544 Midvale Ave. On the Session Setup page, click the Find Source button. Under the Target Display Type drop down, select the display type that is being calibrated. On the Session Setup page, click the Find Meter button to connect your meter. In the Initial Setup section of the Color Cube workflow, step through the following pages:Ĭonnect your color meter to the CalMAN computer. Proceed through the instructions on each step of the Color Cube workflow, using the following notes for AJA LUT-box specifics. In the CalMAN main menu, select Open Workflow Template / Color Cube (3D LUT). The Color Cube workflow in CalMAN is used to create 3D display calibration LUTs.

#Aja lut box vs boxee software#

The AJA MiniConfig software will then be used to load the 3D LUT file into the AJA LUT-box. cube file with the proper Resolve data format for later loading into the LUT-box with CalMAN (as detailed below). The AJA LUT-box does not need to be available during this display calibration and file creation process. This setup guide assists you in calibrating the AJA LUT-box with the CalMAN Color Cube workflow.Ĭreating a 3D LUT Display Calibration File for the AJA LUT-boxĬalMAN creates a 3D LUT display calibration file for the AJA LUT-box without immediately loading the file into the LUT-box. CalMAN takes advantage of the AJA LUT-box features to calibrate a video display with a 10-bit 17x17x17 3D cube lookup table (LUT) for SMPTE video level signals.